I recently purchased an RT pro valve to upgrade my mag. When I installed the RT and turned on the HPA the gun instantly began to rapid fire without me pulling the trigger. I tried shortening the trigger rod but I got rapid fire again... any ideas?
I recently purchased an RT pro valve to upgrade my mag. When I installed the RT and turned on the HPA the gun instantly began to rapid fire without me pulling the trigger. I tried shortening the trigger rod but I got rapid fire again... any ideas?
Check the On/Off o-rings and make sure the on/off pin is the correct length.
Which on/off does it have?
Make sure the field strip screw is at least snug.
It looks like an RT on/off, all the o-rings are good. The on/off pin may be too short, I don't have anything to accurately measure it. On the skinny end it seems to have been ground down or broken off, it isn't smooth on the end.
Good ruler?
The stock pin should be right at .750 (3/4").
A short pin will be more than 1/32" shorter.
Anyone know if you can drop a quad o-ring into an RT Pro on/off cavity?
This pin measures just under 1/2 inch, it must be my issue.
That's pretty much like not having a pin...Originally Posted by Wilson!
Thanks for the info!
evidently sir , you have a broken pinOriginally Posted by Wilson!