I need some help y'all. i have the ccm fittings with the regular and extended posts. It doesn't look right. What's the best way to get it connected?
I need some help y'all. i have the ccm fittings with the regular and extended posts. It doesn't look right. What's the best way to get it connected?
Last edited by jbtamu1011; 08-17-2019 at 07:30 PM.
From what is shown in the picture. The extended post should be on the trigger frame and the standard post should be on the valve.
Sent from my SM-G970U using Tapatalk
I thought you were supposed to point them at each other and put like a 1" piece in there?
I have it like this now. Doesn't seem to be much in the way of my thumb and hand.
Last edited by jbtamu1011; 08-17-2019 at 07:29 PM.
If you look at nummech picture on his site showing off the trigger frame. He also uses an rt pro rail to show it off. Have you tried making a slight adjustment forward when looking at how he set his up to get around the rear rail wings.
Sent from my SM-G970U using Tapatalk
Use about half the macro & take fittings off leaving the posts on. Connect the macro to each fitting & then bolt each one to the post on frame & valve
Sent from my iPhone using Tapatalk
Well had to go this route. Have to have fixed on valve and swivel on frame. No leaking. Can you anno these fittings? Or just spray paint?
Last edited by jbtamu1011; 08-17-2019 at 07:28 PM.
Is that an idiot mark I see on that valve?
Hey now. The valve is not where the attention should be. No wandering eyes in this post. Damn, barely noticeable in person. I'm sorry Tunaman.
Last edited by jbtamu1011; 08-17-2019 at 07:15 PM.
Also, I felt sick to my stomach when I made that little knick.
Butchers!
Yeah, the ccm fittings won't work with that rail due to the wing. It required a pretty flat rail in my experience. It works with the ule rail and Luke's extended rail.
I'm sure more rails work but I only have the two I tested.
Hey guys, so I have some issues again with the fittings. I have an Armada rail now so no big wide wings to worry about. My question is more on the CCM fittings. I have their regular post in the valve and the extended post for AGD in the frame. Is that correct? I'm getting a big leak around the fitting on the frame. Please advise.
Where exactly is the leak coming from? The threading in the frame from the top of the ccm fitting? Is the oring in that fitting free from damage?
Sent from my SM-G970U using Tapatalk
Yes
Sent from my SM-G970U using Tapatalk
Hey guys, still having a bit of trouble with getting my fittings to not leak. If I tighten down the fitting on the frame, it sits below the fitting on the valve. That's with the extended AGD ccm fitting on the frame. How much do i tighten the fittings? Also, should i use thread sealer instead of tape? Is this a good sealer for all paintball use?
Last edited by jbtamu1011; 11-29-2019 at 03:44 PM.