anyone know the oring size that is around the magnet adjuster of the Emag trigger?
im thinking an 005?
anyone know the oring size that is around the magnet adjuster of the Emag trigger?
im thinking an 005?
Last edited by knownothingmags; 02-21-2020 at 10:32 AM.
Try a few, throw all sizes at it then see what sticks.
It's not a critical fitting o-ring so some simple measurements should get you there.
Measure the diameter of the adjuster (o-ring ID)
Measure the width of the adjuster slot (o-ring Width)
Measure the diameter of the counter bore in the back of the trigger (o-ring OD)
My guess would be:
The ID probably wont have a stretch so it's likely to be the same diameter as the o-ring ID
The slot width will probably be a tad wider than the o-ring width to allow for a compression fit
And the ring OD will be 'just' bigger than the bore diameter in the trigger to allow for a compression fit
Check your Buna-N O-Ring chart to find the correct size, it should pretty easy to figure out