Picked up a Karta Emag a couple years back that had been sitting dirty in a gear bag in a friends garage for the last 10 years and have been trying to bring it back to life.

Hoping someone can help me sort this mess out.

Currently gun shoots Mech fine, valve was rebuilt and all that mess. But in elect mode, It will fire a few shots and then stop.

I have a new battery, good charge. I think, having issues with power bricks, but multi says 19v on battery leads. What amperage should the power bricks be? Only received the charger base and no plug with it.

Bought a new hall harness as messing with the connector on the old one made it shoot better. But new harness replicates the same issue, any where from 50 - 100 clicks of noid then will not fire.
Resetting board seems to start the loop over again.

Could the Noid be bad and needing too much amperage to fire? Or would the board be suspect at this point.