Results 1 to 7 of 7

Thread: Air leaking out the side of valve

  1. #1
    Join Date
    Dec 2009
    Location
    Oneonta, NY
    Posts
    11

    Air leaking out the side of valve

    Air has started leaking out the side of my X-Valve. Took it apart, cleaned every contact surface and its still slightly leaking out the hole on the side. I'm guessing there is an o-ring that needs to be replaced, so which one?

  2. #2
    Join Date
    Jan 2001
    Location
    Cottonwood, Az.
    Posts
    8,183
    Replace the reg pin orings

  3. #3
    Join Date
    Oct 2004
    Location
    Mt. Pleasant, SC
    Posts
    2,741
    Also make sure you do not have any lint or foreign debris on them when reinstalling.

  4. #4
    Join Date
    Dec 2000
    Location
    offshore
    Posts
    8,514
    And make sure you check the for snug fit on the other end of the pin before you use them.
    Email me for low prices on ALL AGD Products and more. tunaman5@verizon.net
    Tunamart

  5. #5
    Join Date
    Dec 2009
    Location
    Oneonta, NY
    Posts
    11
    Whats the procedure to remove those two? Of all the orings replaced those where the two that I could never figure out without damaging something.

  6. #6
    Join Date
    Jan 2001
    Location
    Cottonwood, Az.
    Posts
    8,183
    Remove the c clip on the end of the pin or just use a pick and pull it over the clip, the middle plastic spacer has a split in it to make it easy to remove..

  7. #7
    Join Date
    Dec 2000
    Location
    offshore
    Posts
    8,514
    You dont have to take any clip off. Take the orings and spacer off with a pick and reassemble.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •