I've seen them around the forums periodically, solid air lines custom shaped to guns.
I have a Tac One and would like to figure out how to do this for myself and a couple friends. Anyone know a good resource to get started?
I've seen them around the forums periodically, solid air lines custom shaped to guns.
I have a Tac One and would like to figure out how to do this for myself and a couple friends. Anyone know a good resource to get started?
I buy line in 6 foot lengths but most guys just use this
Air Line.jpg
any hand held tubing bender will work, it's like bending new break lines on an old car.
You will need a 1/4" tubing bender. I prefer the older Parker tubing benders over the modern ones.
tubing bender.jpg
Do you use standard pipe fittings for the tube or are the fittings specifically for steel or ally tube?