Hi. I was going to post this in the workshop for fun builds but it appears there’s nothing in there at all, unless it just won’t load for me.

Anyways, what are all the parts one would need to build an Emag (they’re so hard to find I’m thinking of building one). Here’s what I got figured so far:

1. Emag lowers (preferably complete with board, trigger/magnets, sear, grips, solenoid, etc. etc.)

2. Emag/ULE Emag rail (not sure if the same rail would work for both).

3. Battery and battery housing

4. Body/ULE body and ball detention/feed neck

5. Emag/x-valve with bolt and spring

What if anything else is there that I’m missing for building an Emag from the ground up? Thank you

-Kris


Sent from my iPhone using Tapatalk