I'm new to the 3.2 software

[StellarRAD]

I just traded on the forums for a Emag with 3.2 board, and I also got an older 1.37 board flashed to the 3.2.

I have a few questions on what the new settings are.

TS= Total Shoots
SPS= Shots Per Second
ACE= (??????)
SHBF= (?????)

I'm curious to what the bottom to mean, and also any reason why burst mode was removed?

This could just be the mag I got from AO. I don't care about burst mode, because this think is crazy quick since the upgraded board, but just wondering.

Any perferible settings??

Thanks

[stop whining buy a mag]

ACE is Anti Chop Eye. Just leave it at 0 and you'll be set.
SHBF is Shot Buffering. It determines how many trigger pulls the gun will register in X amount of time. The lower the number the more shots it will register and not throw it away. Keep it on 4 unless you have crazy full auto/bounce problems.

[StellarRAD]

Thanks a lot.

[Dayspring]

Actually, it's the # of milliseconds after the initial trigger pull that it will wait before looking for another trigger pull.

So, yes, the lower the #, the quicker it will start looking for another pull. On E mode, a setting of 4 is ok. On hybrid, keep it around 20+. Otherwise the thing will bounce like crazy.

SHBF is Shot Buffering. It determines how many trigger pulls the gun will register in X amount of time. The lower the number the more shots it will register and not throw it away. Keep it on 4 unless you have crazy full auto/bounce problems.