Finished my Pneumag

[leftystrikesback]

So I decided to do the whole pneumag thing, all pretty standard except that I put the LPR in the foregrip. Turns out a palmer's micro-rock fits perfectly inside the stock gas thru grip covering so I decided to go with it.

I love my Y-frame but I bought a used inteli-frame to do the mod on since it's my first attempt. Now that I know what I'm doing I bet I can get the Y-frame pneu-d out too.

Pics!





and lets look inside:

[sdawg]

Hey, that's pretty clever. If you put a 90* barb on the LPR, the tubing could be flush against the rubber fore-grip or even inside of it.

[Toll]

[leftystrikesback]

Hey, that's pretty clever. If you put a 90* barb on the LPR, the tubing could be flush against the rubber fore-grip or even inside of it.

Using a 90 degree fitting might present some problems because of the thickness of the grip, but the bottom line is that I had a straight fitting and didn't have a 90* one to mess around with. It's a good idea though, if I come across one I'll see how it fits.

Thanks!

Well the 1/8 inch NPT fitting is a beast in terms of strength, so as long as the LPR itself is made pretty sturdy then all should be fine!

[Spider-TW]

Nice.

Just out of curiosity; ULT or not?

[Shingo]

Where did you get that T fitting on your Vert ASA??? Really nice setup... very clean!

[warbeak2099]

Really nice! IMO it'd be better if you routed the LP hose up through the rail though.

[leftystrikesback]

Nice.

Just out of curiosity; ULT or not?

yep it has a ULT in it, I don't know if it needs it, I did the ULT first, about a year ago

Where did you get that T fitting on your Vert ASA??? Really nice setup... very clean!

Marshall's industrial supply, as store near me, has all kinds of fittings. I'm sure you can find them online somewhere.

Really nice! IMO it'd be better if you routed the LP hose up through the rail though.

Fair enough, either way there will be some length of hose exposed. I suppose this was the easy way.


Thanks for all comments

[rawbutter]

Nice.