Emag with Bart Parts No-Rider Feedneck

[Muzikman]

Well Bart Hardwick went and did it. He is now making the No-Rider feedneck for the ULE mag body. You might have seen these on alot of AKA guns. I just got mine today and let me tell ya, it's nice. Lower than any other neck out there (that I know of currently).

http://www.bartparts.com

So, whatcha think?



I'll be taking better pics when I go and get my tripod out of the car.

[Aliens-8-MyDad]

looks hott... how much are they?

[wyn1370]

I'll be taking better pics when I go and get my tripod out of the car.

tripod or monopod??

[Lohman446]

Check out the CCM no-pro once.. that sucker is short - CCM has measurements on there page - I don't recall what they were.

[68magOwner]

i have the same rise on my viking, 2 other teammates vikings, and a teammates trix, great feedneck, who cares if anything else is shorter? that feedneck is shorter than any hopper feedneck (i cut my halo feednec to sit even lower, because this feedneck allowed it)

[Muzikman]

Ok, I am not sure how CCM is messuring their necks, but the No-Pro is listed at 1" on their site. I just got out the calipers, and the No-Rider measures in at 1.194" (from top of neck to bottom of threads). Either way, I like the CCM necks too.

[Chronobreak]

how low can you go?

pretty dang low

[Creative Mayhem]

looking good muz!

[Muzikman]

tripod or monopod??

Tripod, that way I can make sure the camera is level as I am shooting down on it. And keep it steady.

[RetroEclipseMan]

Those things are pretty hot. I might just have to pick one up for my freestyle.

[MisterBones25]

where can i get one of these?

[Muzikman]

www.bartparts.com is the website, but it is not up yet. If there is enough demand on AO, I might have Bart set me up as a dealer.

[the123]

I like it Muz, nice find.

[JoshK]

I would prefer a rouge strangler ....that is looking really nice though.

[gibby]

That looks nice. Lemme know if you can get a black one.