ULE Feedneck Removal

[Mer]

Does the stock feedneck on the ULE body just unscrew?

Want to make sure before I try.

Thanks,

Eric

[Automaggot68]

Yes it does.
it's pretty tight, so you'll need a strapwrench and a strong arm.

[trimegatron]

heat it up with a torch or lighter momentarily ( it will not damage the coating)

[toymyster]

Does the stock feedneck on the ULE body just unscrew?

Want to make sure before I try.

Thanks,

Eric

That usualy does it nicely!! It has the same thread as Angel feednecks!!!

[personman]

Yup, I highly reccomend getting a strap wrench. I figured I was never going to use the feedneck again so I just used pliers (and it was pretty hard to use pliers, it would be easier with a strap wrench) and that wasnt smart, but I covered up the scratches with black sharpie so you dont notice them unless you look closely

[TDonovan]

I too have to get mine off.. I'm going to heat it up with a blowdryer since it's helped me work large quantities of red-locite loose.

[Skywalker]

I boiled water and stuck my body in for about 20 minutes. Then used a strap wrench to get it off with ease. Then I put on an A plus feedneck and it looks great.

[TMAXXKING1]

hear is how i did it

i cut a bycyle inner tube put a peice around the feedneck ... clamped the feedneck in a vise and used the body for leverage ... came off pretty easy...... if you cant seem to do it with ease put a barrel on it ... simple no risk to the anno at all..

[Mer]

Thanks for all the replies.

I'll heat it up and use my strap wrench.

Just getting ready for my new Rogue Strangler Feedneck.

Thanks Again,

Eric