Okay, easiest one first.
I made the mistake of leaving my battery plugged into it while it sat around and when I went to play around with it today, obviously the battery was drained. So, I put a new one in. Well, when I switched it on, it just spun continuously. Now, I read in the instructions that if this happens I should turn down something...but of course I didn't know what it was talking about or where that knob was. In my opinion, the instructions kind've do a poor job by telling you to adjust things and refer to them as if you know what they are.
Now, the harder one. I got this warp feed used from a guy that had it set up for intellifeed. I'm thinking of using it on my blowback. Well, anyways, I was reading some posts about how it can work on "sensitivity mode"...yet again, when I read the instructions, I couldn't figure out the whole "jumper" thing. I tried to do what it instructed, but the sensitivity mode didn't work. That was awhile ago...the battery should've been good then...does sensitivity mode require more battery power than intellifeed? Any better instructions on how to get that mode to work. I've read that maybe it could be a problem with the disk or springs or something??