You mean the solder on the board for the connector?
I dont think it would as it has small pins that drop into holes on the board and then are soldered in place. You (or someone else that owned it) would have to pry on that connector really hard to pull it out. You would notice damage like that without fail.
If you ment the connector on the battery snap that connects to the board,... its a pressed/crimped fitting. So I would check it, but rule it out rather quick.
The only thing I would check though is the battery snap itself. Over time, they tend to get weak from normal plugging and un-plugging of the battery. Exspecially if you are doing a mod and have to test it often. I would ditch the snap you have and re-solder in a new one if it looks too old or worn.
If you have some money to spend (no more than $100) I would HIGHLY recommend contacting Damon of Scenario Dreams for getting a better board.
If you ever wanted to have your body (ULE if you have one) drilled for eyes, the board would come redy for them, and he sells them as well in just about every color.
Im going to give a look and see which one might drop in,... somewhere on here someone did this mod. Pretty simple if I remember correctly.
If you do go this route and you find parts wont match (say the connector for the clapper noid isnt the same) post back on here and shoot me a PM. I had a copy of the Hyperframe noid made but with the new 2-pin connector found in all the newer boards. (pictured below is a scan of actual part)
~ P8nt