Guys;
I am sitting in my living room with my fiancee and my daughter right now,.. because its 7:30am on Saturday and its been a rough night
My daughter has a nice case of post nasal drip,.. and what ever she has now,... I have plus a cough (slight though). My fiancee is getting the start of what we have,....
I tell you this so you know that I have not touched the Ripper frame,... I just didnt have time this week.
I have the valve installed and I found my ASA and LPRs I will be using (some how the LPRs went up and walked away last week)
There is a smaaaaaaal problem with the setup (Ryan,.. dont worry!) If you all look at the pictures of the rail, you will notice that it is rather short and indeed will not compliment the ASA that Ryan milled for the Ripper.
I call this to your attention because I want to know how
YOU guys would like to see the demo video footage.
Your choices are:
A) Mill the hole in the rail more forward to allow the use of the ASA that compliments the Ripper frame,... placing the LPR in the front as originaly designed.
B) Place the LPR in ANY location that will work for you,... as long as the frame performs 100% as designed.
I will tell you that option A is not going to be a long waited thing. I have ALL the tools to modify the rail,.... and its just a matter of what you would like to see done. Option B IMHO would look "less appealing" in the video.
I give you the option because my rail I was intent on using in the pictures was milled for eyes. So it gave me the chance to complete the marker 100% as shown in Ryans original video. Can I change the rail out? Yes,... Im just looking for some input here.
~ P8nt