Well, maybe if Clare isn't going to be there....Originally Posted by Smoothice
Well, maybe if Clare isn't going to be there....Originally Posted by Smoothice
SWEET!
So three markers, and one of them, a classic with TKs sig on it.
Also what ever parts that are donated, that dont make it on the marker being built for the charity.
Pm'ed you shipping address for tk's sigOriginally Posted by bunny5
Got it.
Originally Posted by Smoothice
I can do this for sure. LMK.
Dan
Pm'ing nowOriginally Posted by Maghog
The answer is Yes, the Airwalk takes AGD Spec triggers.Originally Posted by Smoothice
Trigger's done, let me know where to send it.
Dan
Same for me with the marker. just need to know where and it will be off
I wii donate one of my pump mag kits to add to a gun or just for the parts raffle.
Maghog & hill- it would be best if you guys shipped to Loguzzzzzz. I'll get you his addy or have him get it to you.
Xm15- that's great! With all the extra parts we will either build a Pumpmag or raffle it separately. I will pm you my addy.
Got the address. i will PM him and let him know its on the way.
Still need a sear and pin?
Unless Loguzzzzzz has a nicer rail I will throw in my venomous designs prototype toxic rail courtesy of venemous designs!Originally Posted by SSP REAPER
So send a rt sear and pin!
I was planning to use a ULE Emag rail that is raw polished. I think that the V-D rail is nicer but that is up to you! Either way, as Smoothice has stated, send me an RT sear and axle.Originally Posted by Smoothice
Any idea what the anno on the airwalk is? The ule body is black. We'll have to see the colors before choosing the rail.Originally Posted by Loguzzzzzz
It has a dust black powder coat, I recived it that way from the original owner. The 15* and foregrip are gloss blackOriginally Posted by Smoothice
I have received the valve and the MiniPneuMag from hill160881. Thanks for the generous contribution!
Loguzzzz, PM me your mailing address and I'll send out the trigger.
Dan
Wish I had some stuff to donate, sold pretty much all my mag parts off.
Someone should donate a sick anno job on these parts, maybe a dust anno so the parts don't need to be polished and what not. (and I've always been partial to dust anno )
wish I could...
not enough time unfortunately.
PM incoming.Originally Posted by Maghog
Haven't gotten a chance to send the marker yet. It will be in the mail tomorrow
Is a sear still needed? I think I have a RT Pro sear laying around (no pin though)... lmk if you need it to finish this build. Also I might have a spare asa or rail or something if any other finishing bits are needed (air fittings etc.).
This is a great project!
When and where is the auction/raffle? I could donate some SS braid if needed.
sent!
You guys are all nuts! But in a good way. Very very generous of all of you guys!
The Triggernomics trigger arrived today and it is as beautiful as you all know is would be!
Big Thanks to Maghog for the wonderful goodie!
I am still waiting on a few pieces.
Just a friendly reminder that I need a little time to complete the build and test it!
Thanks!
John I will ship tomorrow. Which valve are we going with?