Originally Posted by
Syko89
I am just got a warpfeed and noticed that the rotor feed neck is to big for the warpfeed. Should I file down the feedneck the warp shell or loosen the upper shell screws and then tighten with the rotor in place
I never tried a rotor in a warp. How much bigger is the neck of the rotor than the feed hole in the warp? If there isn't much difference in size, loosening the screws will work. If there is considerable size difference, all you will do is crack the warp shell when you try to tighten the case screws. Its probably best to sand down the rotor feed neck or get an a adapter.
Except for the Automag in front, its usually the man behind the equipment that counts.