Damn, I think I said this a while back too. Would your milling be available on these rails?
Damn, I think I said this a while back too. Would your milling be available on these rails?
Please review post number 1 for details.
i would be down to just buy an extruded style rail with no outside milling
That would not be a problem.
I realize these would be AM/MM style rails with variable length... but is there anything really prohibiting milling/tapping these for an RTP style sear and pin instead of the drop-in AM/MM style?
No. That is not an Automag/Minimag rail, that there is an RTPro rail.
An unmilled AM/MM rail will look exactly like the picture in post #1.
Figured you are looking at this so I'll put it here. Would you be willing to make the brackets part of a T2W stock? We would have to find our own actual "stock" part to attach but the bracket themselves could be made.
I'm sure I can make them if we can muster an order to make it worth the effort.
I'm trying to keep this thread focused on AM/MM rails though.
I won't interrupt anymore with this. Just thought it was a good idea.
No problem. Start another thread and we'll see where it goes.
was this going to be available?
Really I was just testing the water for Automag rails and it pretty much looked like there was no interest, everyone seems to want RTP style rails. I have no problem doing them, but it's a big enough investment that I really need solid interest in the project, I'm not sure we got there. (???)