Air has started leaking out the side of my X-Valve. Took it apart, cleaned every contact surface and its still slightly leaking out the hole on the side. I'm guessing there is an o-ring that needs to be replaced, so which one?
Air has started leaking out the side of my X-Valve. Took it apart, cleaned every contact surface and its still slightly leaking out the hole on the side. I'm guessing there is an o-ring that needs to be replaced, so which one?
Replace the reg pin orings
Also make sure you do not have any lint or foreign debris on them when reinstalling.
And make sure you check the for snug fit on the other end of the pin before you use them.
Whats the procedure to remove those two? Of all the orings replaced those where the two that I could never figure out without damaging something.
Remove the c clip on the end of the pin or just use a pick and pull it over the clip, the middle plastic spacer has a split in it to make it easy to remove..
You dont have to take any clip off. Take the orings and spacer off with a pick and reassemble.
Registered User