Originally Posted by
SR_matt
Ok stupid question because I am having a hard time tracking down the actual measurements as well as exactly where you measure between.
The number I have seen is 1.985" which I assume is from the tip of the pin back to the back of the sear where the pin connects to (while holding the pin at 90* to the sear part it connects to). Do I have that right? Is there a +/- tolerance for that?
Main reason I ask is that before I put this marker in storage in the 00s I had screwed with the length of the trigger rod trying to fix an issue that likely should have just been fixed by removing the front trigger stop I had. I have a second sear but its not measuring correctly (closer to 1.913") so I am not sure if I had bout one preset for the classic RT as an extra back when I first built it.
Thanks