LVL 10 Superbolt ll is too wide
I finally received my beta lvl 10 upgrade,after I
assembled the powertube,I put the bolt on and tried to
install the valve.The valve wouldn't seat,I finally
realized that the bolt wasn't going thru the washer inside
the main body,my original bolt goes thru fine,but I couldn't
get the superbolt II to go thru.It seems like there is a bit of a bulge on the tip of the bolt any suggestions would be appreciated.This is on my emag.
E-Mag #00511 (12in Dye Alum)
Clear Warp
68/3000 AGD Flatline
12V Rev-
Minimag
9v Rev
68/3000 pre-set