Looking for a LAPCO universal vertical feed-neck, as they've been out of stock forever.
I cannot use my marker without one, the plastic spyder ones suuuuuck.
Looking for a LAPCO universal vertical feed-neck, as they've been out of stock forever.
I cannot use my marker without one, the plastic spyder ones suuuuuck.
Might I suggest, that instead of trying to find a unicorn(you might have better luck with some like I&I sports, the big warehouses) that you look at something you can get more easily?
Since it is a slide on feedneck, what about the Empire universal feedneck? But you'll say, there is nothing to hold onto(if the diameter of the spider feedneck is comparable). But I will say, "you could dimple the side of the feedneck, from the inside, giving you a purchase are that would lock into the Empire's locking ring."
I would suggest dimpling the actual side, so you would have to turn the feedneck 90°, so at the separation point of the feedneck, slides over the dimple, but you turn it 90°, and it locks in, as it were. It might be slightly ghetto, but if it works how I think it would, I means you get onto the field with a locking feedneck with about 5min work with a hammer, a punch, a reset block(basically something to control of the dimples depth) and the will to do it.
I wonder if this could be adjusted to work, maybe with shims ?
https://lukescustoms.com/feed.html
Cut the threads off, cut the coller so it can get smaller, and use it as the shim I mentioned.
There you have it.
Worth a shot, nothing else to use unless Simon makes something.
Thank you
de nada
The spider feedneck is much thinner than a mag feedneck. I don't think that your feedneck will work. I could be wrong but I am pretty sure I am not. That is why the feednecks needed a 1 off special feedneck adapter/elbow.
The feed tube I'm trying to fit for is .875 in diameter. The same 7/8 feed-neck that spyders use. It's for a forgotten marker that the threads are no match for any feed-neck that i know, my thread gauge is closest at 27 tpi, but it looks like 26 or possibly 25 tpi but certainly not 24. Unless you guys know the thread per inch of other feed-neck types then IDK myself. I haven't been able to match it up with any others yet.
Gotcha, I thought you were looking for the Spyder slip-on feednecks. Sounds like what you really what you need is a 26tpi threaded neck ring
Yeah pretty much. FYI, its for an Inspire BFG. Also known as TG101 by Air Challenger, a Taiwan based supplier that also did the MG-7. Likely a 7/8-26 tpi threading but i don't know what other markers use that. It just came with a 7/8 neck with separate clamping adapter like the old vert spyders.
I may be able to help you out here. However, the key word is may, so don't get too exited just yet. Does it have to be a LAPCO feedneck, or are you OK with any clamping feedneck fitting a BFG, as long as it is in aluminum?