E-Mag Battery Pack ASA Manifold

[luke]

Emag Battery Pack ASA Manifold
$37.50

This is a replacement part for your AGD factory top.
It allows you to mount a regulator inside a factory pack for a sleeper pneumag.

Comes with two 10-32 mounting screws and one 10-32 plug.

This requires a slot in your rail to mount the pack.

You should be able to use it on any rail of your choice including an AM/MM rail.








The picture below shows the inside of the pack from the bottom view.
Regulator and Microline fitting shown in picture.

[ezcreation]

Awesome idea man!

Do they come in black?

[luke]

I could be pursuaded to powdercoat one black for you..

[micromag-man]

What about those of use who don't have a spare battery housing laying around?

[luke]

I guess you could mount it without the housing.

(I know that's not what you were getting at :) )

Tunaman??

[Dend78]

woo hoo these are looking sweet man



for the Packs i know PTP has several mids laying around but you would need a bottom and bolts but it should be good to go then, and there is always people with complete packs laying around just post a WTB complete emag battery pack and see what pops up.

[Sundown]

wow that is an excellent idea :)
nice work

[luke]

Awesome idea man!

wow that is an excellent idea :)

The original concept started with FiXeL as far as I know. I'm not sure if anyone did one before him. Just for the record, I did run this project by FiXeL before I started it. Also, I was contracted by Dend78 to get the project on wheels.

[Dend78]

payment sent

[Hook]

Now that is an amazingly ingenious idea right there!

[Sundown]

The original concept started with FiXeL as far as I know. I'm not sure if anyone did one before him. Just for the record, I did run this project by FiXeL before I started it. Also, I was contracted by Dend78 to get the project on wheels.

you are right I do remember seeing a thread on this by Fixel.

great idea anyhow to all of you :)

[BlueDragonX]

A recommendation...

If you drilled a second hole, or widened the LPR hole, you could also use the pack for storing electronics.

Just a thought.

[p8ntbal4me]

The original concept started with FiXeL as far as I know. I'm not sure if anyone did one before him.

Fixel also offered his drawings to any machinist for use as well.....

,... I remember seeing that posted in his thread.

~ P8nt

[afortuna]

Time for stupid question

What is the microline fitting for?

[Dend78]

What is the microline fitting for?

for whatever you want to use it for, i believe its same threads as the macroline so you can run a macroline up through the bottom or you can just plug it