What screw in HPA systems have 850 psi output?

[WSCopic]

I have been seeing that it is recommended to have 850 psi output or higher on Mags. I have a Pure Energy screw in and a Dynaflow 420 (not sure of the output pressure on either)

If neither of these are good for the pressure needed, can someone throw me a couple of ideas for an alternate tank? Besides a Flatline.

Thanks.

[minimag86]

Crossfire makes a nice 850 fixed output tan/reg........ http://www.crossfireinc.com/

I have been seeing that it is recommended to have 850 psi output or higher on Mags. I have a Pure Energy screw in and a Dynaflow 420 (not sure of the output pressure on either)

If neither of these are good for the pressure needed, can someone throw me a couple of ideas for an alternate tank? Besides a Flatline.

Thanks.

[Coralis]

Unless the regulator says its a low pressure regulator it should be outputting 800 - 850 psi , that said the dynaflow will probably have a better recharge rate for more consistency.

[Pzippy]

Basically any HP tank will have the output pressure you need.

[Warwitch]

Crossfire makes a nice 850 fixed output tan/reg........ http://www.crossfireinc.com/

800 psi actually. Personally I love my Crossfire for its consistancy. Got hooked on them when I bought my Viking and have been using them ever since.

[robnix]

I have been seeing that it is recommended to have 850 psi output or higher on Mags. I have a Pure Energy screw in and a Dynaflow 420 (not sure of the output pressure on either)

If neither of these are good for the pressure needed, can someone throw me a couple of ideas for an alternate tank? Besides a Flatline.

Thanks.

NitroDuck iReg piston kits come with a 1000psi piston.