Have an RT Pro with Level 10 bolt. Bought the marker new around 01 and put the level 10 in late 03 I believe. Never had any problems with the marker and thought was the greatest thing since sliced bread. Unfortunatley I had to put the marker into storage first part of 04. Everything was perfectly upkept oiled and taken care of, even before put into storage. Finally got a chance to get back into paintball this week so I recovered my RT pro did a basic wipe down and re-oil. DID NOT TAKE THE VALVE APART AT THIS POINT!!!
First time I aired up the system and pulled the trigger marker went full auto on me. Since that time I've tried every spacer, every shim, every spring, and every combination thereof that I could think of. Even put he original level 7 back on the valve(not sure I used the proper power tube bottom oring though) . Changed every o-ring in the valve. But still all I get is air down the barrel or ocassional brief full auto without even touching the trigger.
Not sure the sear is the problem either because regardless of the combinations I use I get one of two main results:
1. Pressure turned all the way up and still not enought pressure to the trigger or,
2. Leak down the barrel regardless of pressure setting
Only last thing I can think of is that even my replacement orings have hardened too much after sitting for so long.
Thanks for any help!
First time I aired up the system and pulled the trigger marker went full auto on me. Since that time I've tried every spacer, every shim, every spring, and every combination thereof that I could think of. Even put he original level 7 back on the valve(not sure I used the proper power tube bottom oring though) . Changed every o-ring in the valve. But still all I get is air down the barrel or ocassional brief full auto without even touching the trigger.
Not sure the sear is the problem either because regardless of the combinations I use I get one of two main results:
1. Pressure turned all the way up and still not enought pressure to the trigger or,
2. Leak down the barrel regardless of pressure setting
Only last thing I can think of is that even my replacement orings have hardened too much after sitting for so long.
Thanks for any help!
Comment