mag not working.

[Jason R]

I have a minimag and for some strange reason it vents air and doesnt cycle all the way. i oiled after i last used it and now it just shoots full auto and the bolt wont finish a complete cycle. and if i adjust the pressure and try it it just vents air and the bolt sticks. any help is much wanted. thanks.

[Jason R]

i also think my mini has a lvl7 kit installed as of now. any help? when it shoots/cycles it sounds also watery.

[mstrdbz]

Start with your air supply, make sure you've got enough pressure to cycle correctly. Then go to the on/off, make sure all the orings are still in good condition. Lastly, check your bolt and sear for wear, as well as unrestricted movement.

What is your setup? (Valve, body, frame, etc.)

[athomas]

Replace the bolt spring. A weak or worn one will cause bolt stick and strange firing issues.

[pierce]

You could check your power tube o-ring also.

[Jason R]

i know very little about mags but everything looks fine to me. i may ave to send it into AGD for repairs. i have no idea about what could be wrong.thank god i have 3 warrenty stars. and how do i register my mag?

[Cleric]

do the system check, see if it leaks holding the trigger in, the sprinkler sound, etc...its all online/in the manual

[Jason R]

it only leaks when the trigger pulled and the pressure is high enough

[Cleric]

that would be the power tube oring if im not mistaken

[Jason R]

does anyone have a number i can call so i can see if i can send it in? id like to to a rt swap thing or can i not do that?

[Jason R]

and how do i put a new power tubo oring on?

[cdc120602]

http://www.airgun.com <-- You'll find contact info there.

To put a power tube o-ring in: Remove power tube tip and spacer. Ensure that there is no power tube o-ring there. If there is, remove it. Place new o-ring in power tube. Replace power tube spacer. Replace power tube tip.

[Jason R]

ive called the number and it comes up as a cellphone number. is it supposed to be a cell number? if not then i messed up somewhere. thanks for the help guys.

[Jason R]

also the valve is a 68 Automag A.I.R. Valve. if that helps at all.

[cdc120602]

Before you go spending money sending it in, take it apart and make sure you have everything. http://www.airgun.com/downloads/valveexplodedview.pdf <-- There's the exploded view diagram. If everything's there and it's still not right, get a repair kit. It should come with all the o-rings and a new bolt spring. I think before you do all that, though, you should check your sear and bolt for wear. That is, of course, if your power tube o-ring is ok.