i wanted to know if anybody out there has tried dying the warp housing and if so, how it was done. thanks to whoever replies.
-
E-Mag w/ No-Rise lvl 10
Team Exotic Elements -
ya i have, you need to get some Rit dye and then put the required amount in water then put it on the stove till it gets like 145 degrees and put the warp shells in. leave them in until they are the color you want them. just be carefull you dont loose anything when you take your warp apart and also keep stirring it or it will probably melt the plastic if it sits on the bottom too long. -
thanks for the helpE-Mag w/ No-Rise lvl 10
Team Exotic ElementsComment
-
you might want to try suspending the part in the water so it doesn't even hit the bottm.Taking a long needed leave of the sport to finish school and tour the country
b2k3w/pds, vaporized, vapor valve, aka sidewinder, chaos chip, palmer rock lpr, CP barrels, 68/45 hyperflow
B2k3 w/pds and bunch of upgrades for saleComment
Comment