Hyperframe, and Warpfeed.. chopping

[Dubstar112]

I was using turbo mode to get rid of some old paint with my hyperframe and warp. After about 100 rounds of short bursts, I began chopping during a hypermode frenzy. It would chop every 6 or 7th ball. To me it seemed like the warp wasnt spinning fast enough, but I had tried 2 sets of "fresh" batteries and it still did it. Or I may have my sensitivity too low, but Im pretty sure that it is set right. Also, i have my warp so it spins about a 1/4 a turn every time. Is this too short?

Also.. I've been considering trading my hyper for a Z grip but I want to know how easy it is to intellifeed the Z..(Or, I might wait till the next batch of Z grips come out with the bracket built in.)

[LaW]

do you have your powerfeed plug adjusted right? They could have been hanging up..

[Paintchucker]

Retro Valve???

Do you have a retro valve and nitrogen? You could be outrunning the valve. Or at least that was my impression of my hyperframe on my gun before I upgraded to retro valve. You might try making the warp spin longer, I dont know. When you said "old paint", how old is old???

[SoupRman]

very easy to hook up an intelli-z. just follow the directions on how to hook up the intelliframe, using regular lever switch no roller. youw ill have to drill through the grip frame of the z (internal) and just put the wire through there to solder to the microswitch, and mount it behind where the sear would go. a couple of adjustments and yoru done. i have a pic of the inside of the Z in here i think.

http://home.houston.rr.com/paintballkingz/autobody.html

[img]ftp://paintballkingz:[email protected]/automag/AUT_0646.JPG[/img]