I'm having trouble gettin my ult back in my valve, I bought my gun used and the ult was in but I took it out and put the r/t one in(wanted to try them both out). I found out the pin in the rt on/off is messed up so i'm trying to put the ult back in but in wont fit. The square top catches on to the edge of the rectangular part of the hole in the valve...what do I do? Sand it?
-
-
First... Post a pic. -
Comment
-
Is the edge of the on/off brass banged up or nicked?
Or do you have too many o-rings in there?Comment
-
That's not a stock reg body is it?Comment
-
Take some pics with the camera farther away, so they are not as blurry.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
-
Did you remove th 2 o-rings that is used ontop of the RT on/off???? The ULT doesn't use them.Comment
-
above
Sounds like you forgot to remove the orings from the old RT on/off like flying said. I would know I just recently did this on my pnuemag while testing the ult and rt on/off for any noticeable differences.
-Mike BrothmanComment
-
Yep thats what it was, thanks guys.
Should the silver pin behind the trigger go back into the grip frame when tilted back? In all the pics I see the pin sticking out but mine doesnt, it barely pokes out from behind the little hole(unless tilted forward).Comment
-
No prob on the helo. With the sear rod that's normal.Originally posted by SulleighComment
Comment