a really stupid question on warpfeed...

[druid]

Is this all I need to make the warp feed on every shot? My frame is a standard Classic single trigger mech frame. There is no other poser source for this configuration? Or is it powered by the warp itself and fed by closing the circuit in the microswitch? Is that a reasonable assumption?

The parts I have listed are two conductor, 2.5mm Phone plugs x 2; a two conductor 2.5mm Phone jack NC Circuit w/ 4mm mounting hole; SPDT Switch with roller ball and 22 or 24 gauge wiring. I've got the original wiring diagram from the warpfeed section and made this in paint to represent what I mean........but is this going to work when I mod the inside of the frame for all of this and just plug it in?




Thanks in advance.




.

[Pzippy]

http://www.airgun.com/downloads/intelliwarp.pdf

^^^very helpful.

[druid]

Yes I know I've seen that...but that's for the intelliframe. I'm looking to do this to a standard, single trigger mech frame.

[Madmarx]

Trigger doesn't matter. The system is the same.

I think you want to rotate that switch 90* to the left.
It actually works off the the back of the sear.

[druid]

Trigger doesn't matter. The system is the same.

I think you want to rotate that switch 90* to the left.
It actually works off the the back of the sear.

Excellent. Thanks.

So then it's like I said...the power that runs this set up, actually comes from the warp's intelli-jack...and the microswitch that "closes" when the trigger is pulled, completes the circuit that makes the warp spin?

[Madmarx]

Yeah you're just installing a switch in the loop.

[druid]

awesome. Thanks guys!

[slasherdan]

Yeah the only stupid question is the one that doesn't get asked.

[luke]

http://www.lukescustoms.com/page0005.htm