i just got my new minimag yesterday its awesome havent shot it yet. couple questions. my safety is really loose if i put the safety is on you can tip the gun over and the safety will turn off is there a way i an tighten this up? for now i just took the safety off. and on my body at the base of the feed tube there is an 0-ring what is the purpose of this, my brothers 68automag doesnt have one? onle last question, should i invest in a power tube spacer kit is it needed? thanks.
-
-
To fix your safety, take the grip frame off and above the safety pin, on the top of the gripframe, between where the grip meets the body rail, there should be a little hole on the left hand side when holding the grip in the 'ready to shoot' position. In that hole, there should be a small set screw, with a spring, and a ball bearing beneath it, the set screw puts tension on the ball bearing beneath the spring, which holds your safety in place, either tighten that screw down some if its loose, or, call AGD and get the set screw, spring and ball bearing if theyre missing. Im sure they'll send them out for free. I'll take some pics of what im talking about and post em here in a few minutes. -
there is no spring.Comment
-
Here's a pic of the top of the grip frame, showing the hole where the parts are mounted.Comment
-
Here's a pic of the thre components that hold your safety in place and the orientation of the parts as they are assembled in the grip frame. first that goes in is the ball bearing, above that is the tension spring, and last is the set screw. The O-Ring about the base of your powerfeed is there to either prevent air escaping out the vents and make the powerfeed a little more effective I think.... as for the power tube spacer kit, its always a nice thing to have on hand, but unless you plan on buying more bolts or gripframes and such that effect the operation of your 'mag you'll probably need some eventually.Comment
Comment