Hyperframe issues

[darqueMeye]

So i just got my hyperframe back from luke. had the 80g switch installed and the wings milled off. So i install my hyperframe and i cannot get it to fire. it seems like the sear isnt pressing the soleniod in to reset it once i pull the trigger. i have a rt pro rail/ sear, ult, x valve. Any ideas??

[AirAssault]

Try loosening your front grip screw and if needed undo your field strip screw a LITTLE. Then try it. Not sure if you can adjust your dwell or not but if you can do so.

[darqueMeye]

Try loosening your front grip screw and if needed undo your field strip screw a LITTLE. Then try it. Not sure if you can adjust your dwell or not but if you can do so.

not even sure how to adjust the dwell.. need info pls.

[p8ntbal4me]

not even sure how to adjust the dwell.. need info pls.

Im assuming that your have the stock 13bps board. I dont own a 20bps board so here is the trick to adjust the dwell on the 13bps board.

When you turn the frame on,.. press and hold both buttons at the same time to go into "service mode". From there you can change your dwell.

Look up the "hyperframe" on Centerflags web page (the manual is still there)

~ P8nt

[darqueMeye]

Im assuming that your have the stock 13bps board. I dont own a 20bps board so here is the trick to adjust the dwell on the 13bps board.

When you turn the frame on,.. press and hold both buttons at the same time to go into "service mode". From there you can change your dwell.

Look up the "hyperframe" on Centerflags web page (the manual is still there)

~ P8nt

thanks ill give it a try when i can. and yes its the 13bps board.

[darqueMeye]

So i figured out how to get into service mode. Fixed the issue and now its shooting great! Thanks.