i just got my emag back from AirAssualt and i was dry firing and on hyper with the rate of fire on 25. then it stopped working no more clicks. soi opened it and one of the wires from the solnoid was not connected to any thing. so i held it where it goes and it sets off the selonid. the selonid just stays retracted and the board heats up. but the board turns on and works fine and
-
Last edited by cocopuff; 10-29-2007, 05:27 PM. -
solder the lead back on, and stop trying to "hold" it on! more damage could ensue.
and stop messing around with 25 bps...I sure hope you didn't burn out the board and/or solenoid
Comment