who has a ULT in a AIR or classic valve?

[pump]

i got bored and installed a ULT into my old AIR valved mag

weirdly enough im getting a fully recharging trigger and not short stroking shots

i need to see how it works with balls but so far im amazed its working



anyone else have similar results?




i tunned it different that the instructions

i left the bolt off the gun

held the trigger down and released it.....if the vent sound was too light i added a shim...when i added a shim without a noticeable difference in sound i took out one shim and left it as is


i think this will help my battery life with my booyah frame some...well see

[dyeforever]

i got a ult in my classic. i get some bolt stick once and a while, but im goin to turn it into a pumpmag so it doesnt bother me.

[pump]

is the bolt stick caused by the on off pin not fully closing?

[Coralis]

I use a ult in my hyperframed micromag and never had any problems with either classic valve i have. I have two shims in it

[pump]

i have like 5 in mine.....wouldnt open at 2

[punkncat]

Does it lighten the trigger just as much as in an Xvalve?

I tried the RT pin mod in my classic valve and could never get it to work right. I have not tried with the ULT.

[mh53eplt]

who has a ULT in a AIR or classic valve?

Did the same to mine, works great! Was a pain to fine tune though.

[pump]

would you share with me your problems tunning

the only problem i have tunning the ULT is that it leaks through all the time(either the pin or the body)....but not on my AIR valve but my friends Xvalve, so im happy about that hahahahahahahahahaha