Bare Emag Lowers with Mechanical Shooting issues?

[mr doo doo]

Well, not so sure if this is normal or if it is a real issue, but i need to know whats up before i move on into my project:

So, i picked up some bare emag lowers so i can make a regular mechanical mag, just with emag lowers, but i was a bit hesitant if it would work. So i slapped on a Rt Pro rail with a typical RT sear, Pariah body, classic valve, and the lowers itself to see if it will work. The issue is: i cant pull the trigger all the way because the body is blocking the sear from finishing off. Found this out by taking out the valve, pulling the trigger all the way, resulting in the body being lifted near the valve end.

i took everything electrical related, even the switch for electric mode of mechanical mode. whats up?

[NU_METAL]

look to see if the back of the sear is hitting the safety -even when its off - i had an issue w/ my xmag this was effecting the higher R/t rates of fire
if its rubbing / hitting
you will see the sear arm kinda shinny and smooth from friction
good luck oh and make shure you have the emag pin thats shorter in the on/off

[athomas]

Everything you have should line up perfectly. Check to see if the rail bushing is in place. If the sear is hitting the bottom of the body, then something is allowing the body or the sear to be out of place.