This may not be thread-worthy, but I am a noob here and I am determined to act like one. I ordered (and received) one of those stainless direct feed bodies (the ones they call "collectors items") from AGD. I was waiting for my Docsmachine cocker thread adapter (which I thought would never arrive and was cursing Doc, but then it did and now I worship him 
) and got impatient. So I tapped and threaded a hole right in front of the feedneck. I put in a set screw. Then I got the barrel lined up with the feedneck (it was not a direct feed twist lock barrel- that being the whole point) and drilled a small recess in the thick twist lock back part. Worked pretty good... except I measured badly on the first hole and put it on top of the o-ring channel. I play scenario mostly (so i'm not vain about looks) and like stainless. So anyway... I thought I might share. 
) and got impatient. So I tapped and threaded a hole right in front of the feedneck. I put in a set screw. Then I got the barrel lined up with the feedneck (it was not a direct feed twist lock barrel- that being the whole point) and drilled a small recess in the thick twist lock back part. Worked pretty good... except I measured badly on the first hole and put it on top of the o-ring channel. I play scenario mostly (so i'm not vain about looks) and like stainless. So anyway... I thought I might share.
Comment