PumpMag Body Milling Comparison Pics

[PumpMag]

Comparison, side by side Pump milling:



Left: Pump milled ULE Body
Center: Original Factory Cut Pump AM Body
Right: Dremel Cut AM Body

[dyeforever]

thanks pumpmag. this is the pic ive been looking for.

[snoopay700]

That dremel one almost looks like that groove isn't supposed to be there, it just looks so...unfinished. Glad to know that i can do it with the tools i have available though, thanks.

[PumpMag]

Yeah, the dremel one doesn't look pretty but it does work.

It came this way from the original owner when I bought the AGD pump kit from him.

[PumpMag]

thanks pumpmag. this is the pic ive been looking for.

No problemo. I finally had time to take the photo. Also, this thread just happened to be my 400th post!

[snoopay700]

No problemo. I finally had time to take the photo. Also, this thread just happened to be my 400th post!

Yeah, if it weren't for me coming to this thread and then disappearing for a while, then coming back and repeating, my post count would probably be embarassingly high, i'm glad that it's not much higher than yours though as i've been here 9 months longer, but congrats on that 400th post, now you gotta go for 500!

[race]

rail pic ?

any pics and advice on milling the rail and body my self is it worth paying for it i can do fair work and have done well with coustom stuff before alot of patients and a little cussing gets the job done every time

[race]

i know

i just saw this was a old thred

[Spider-TW]

It's still a good pic and it's not too much of a necro post.

[PumpMag]

any pics and advice on milling the rail and body my self is it worth paying for it i can do fair work and have done well with coustom stuff before alot of patients and a little cussing gets the job done every time

Might save you trouble to go through all the work, trial and error, etc. Just check the BST section and dealers section, the prices are reasonable if you comparison shop, you can have them milled or buy them used.