problem with elcd boo yaa

[Warbeast]

hi

my elcd booyaa frame isnt working right
how much space must be between searnoid and sear plate?
tried 2 different rails and 2 different sear plates
and not getting forward

greetings Phil

[athomas]

Are you using a ULT on-off? These work best with the electronic frames.

[Warbeast]

hm, how das an ult look like?
in the on off is a very small pin, not a fat one like in teh classic

[Warbeast]

i rebuild it, in the original minimag ral and body it runs like hell
but in classic rail with z body it wont

[MANN]

hi

my elcd booyaa frame isnt working right
how much space must be between searnoid and sear plate?
tried 2 different rails and 2 different sear plates
and not getting forward

greetings Phil

Good luck with your project. Boohyaah frames have always given problems. Your best bet is to use it with an RT/E/X valve, and use a ult.

Or just sell it, and get an emag.

[divil]

hi

my elcd booyaa frame isnt working right
how much space must be between searnoid and sear plate?
tried 2 different rails and 2 different sear plates
and not getting forward
greetings Phil

You have to move the solenoid forward or back. There is two screws under the solenoid to loosen it.

[pump]

i pushed my noid all the way back

make sure you have a booyah hyperframe RT or ULT in there or it wont work at alls