I have a micromag and got a xvalve and it wont fit 
Do i need a reverse xvalve? You can see my gun below
[IMG]
[/IMG] [IMG]
[/IMG]
Do i need a reverse xvalve? You can see my gun below[IMG]
[/IMG] [IMG][/IMG]
-
-
Does your Xvalve also have a L10 bolt? Occasionally, a L10 bolt won't fit into the Micromag body well.
Pics of your bolt would help. Of course, if your valve just won't fit, I would be willing to take that body off you.
custar -
the valve has lvl 10. how much you trying to pay?Comment
-
PM'd.
custarComment
-
Simply get some sandpaper and sand down the tip of the bolt a little bit until it fits fine. It's not an uncommon problem. Shame on you custar for trying to profit off his problem.
http://automags.org/forums/showthread.php?t=53833
There's an example of someone else having the same problem. If you don't believe me, look at the first reply by BlackVCG who is a certified AGD tech and used to be an administrator here on the forums.Comment
-
custar =
Comment
-
I had to sand mine down to get it to fit.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
-
me too .... took about 20 - 30 minsComment
Comment