Classic Pnuemag on/off help
I have seen other Classic mags that have been turned into sleepers with a pneu conversion. i have tried to do the same with my classic valve and have no luck in getting it to work right so i need a little help. I have installed a NEW RT on/off into the valve and put it on a am/mm rail with a new sear and when i air it up it runs away on me. To check things out i had put in an Xvalve with a ult on/off and it works fine. After playing with the set up for a while i could not get the classic valve to come out of the body. After breaking it all the way down i discoverd that the on/off pin was stuck in the body. So i wiggled it around a managed to get the pin to go back in and when i removed i noticed the small o-ring had broken and a small peace and made its way between the two halfs of the valve. Cleaned it out and put a new o-ing on it and the same thing has happend to the small o-ring about 5 times now. So i am stuck and dont know what to do to get this to work right. Just for kicks i put the RT on/off into the Xvalve and set it up and when i aired it up I had no runaways but the on/off o-ring did the same thing. I had to wiggles the pin for a while to reseat the oring so i could get it out of the body. HELP ME PLEASE 
Comment