I just got back into some ball and my minimag is all stock other then a dye barrel. The trigger is hard to pull and long. Ive been looking at the ULE triggers, it says it only 15oz and a short pull. Question is , is it worth it or will the Intelli-frame be a better buy and do the same thing. I can find one on here for about 20.00 more then just the trigger. Just looking to shoot a little faster
-
-
Trigger
The ULE trigger kit isnt recommended for the minimag valve. Its not actually a different trigger it has to do with the On/off on the valve and maybe the sear, but i dont know what all it changes.
if you just want a little shorter and easier feel try going with the RT pro on/off and sear setup. I got mine like that from the start so I dont know how much better it is, but my friend changed his mag to the same setup immediately after firing mine. Warning though, I have an RT pro rail so make sure everythings compatible with the MM rail if you go this way. A double trigger frame is also nice for helping out a bit.
If you want more speed you can go with a reacitve valve or a pneumag setup, but these are pretty extensive in either time and/or money so make sure you want to fire considerably faster. You will need an hpa system, good loader, L10 bolt, maybe more. -
thanks for the info, what about the Intelli-frame will this work with the minimag. I'd like to make it faster but iam not sure if its worth the money i'll need to put in it or if i should just buy something new.Comment
-
Itelli
The intelliframe should bolt right on without issue.
couple questions
How fast is "faster"? Do you want to shoot 3 balls per second or 10?
Do you have compressed air or CO2 as your air source?
What Hopper are you running?
how much $$ do you have for the project?
how's your crafting ability?Comment
-
i'll post back after work.
this is what iam thinking. RT valve and lvl 7 w/ the intelliframe , would it work with the minimag and is there any other parts i would need. would this be worth the 170.00Comment
-
decisions
first, no it it isnt worth it imo. You can find a complete RT marker for close to that probably with a level 10. Parts wise its about right but depends on if its an origional RT valve or a RT Pro just for compatability.
2) You would need an RT pro (ReTro), emag, or xvalve to have it work on your setup. the origional RT valve needs a lot of air pipeing the other mags dont have. dont buy one unless its a complete marker. dont know about compatible sears so you will have to research that yourself.
3) You must have an hpa tank for any reactive valves, so if you dont have one factor in the cost. Also you want an adjustable reg if you want it crisp and fast, so factor in that cost as well.
4)If you have an uber hopper and trust it you can go with the level 7, but i dont recommend it. I wouldnt shoot a reactive valve without a level 10. factor in that cash too.
5) if you really want the intelli go for it (I did), but honestly if you go reactive there isnt much use for it. You dont need to walk for speed in the reactive world. Unless you have lots of $$ or already have the good tank and loader, Id put that money someplace else.Comment
Comment