powertube seal broken,...again!

[Chronobreak]

Well the red o-ring that holds the seal between the powertube and dump chamber has broke for the second time.

ive never had this problem with any other mag/s

two questions, where do i get a replacement, i tried calling AGD ..no answer..go figure and emailed tuna with no responce yet.

can i use Teflon to seal it up or os that not enough?

[Shane-O-Mac]

I would try red loctite. 2 drops, let it wick around the threads and settle into the thread valleys. Then use a q-tip to dab up the excess, and install. Thats they way we used to do air fittings for AA, and when done properly the red loc-tite wasn't permanent, or hard to remove. You could try Blue, but it doesn't fill gaps as well as red. Is this on a Classic valve? or an X-valve?

[Chronobreak]

it had a ton of red loc tite on it when i removed it, thought it wasnt difficult to remove per say...

this is just the second time it has happened and im wondering if this is an indication of a larger or more sever problem.

i gotta get this working so i can shoot you guys up this weekend

[Chronobreak]

thanks shane, leak is fixed and seems to be holding.

i think my sear is a bit outta spec but its working