emag will not fire

[Ruler_Mark]

lets say the temp it sat at ran between 50 and 75 degrees.

Pre-sitting it was used about twice a month for about a case a month paint. Total shots >20000. Never had an issue, so its the fact it was sitting.

Can you tell me how to get the solder off so I can test the noid off the board? There is someone I can get a used noid off for 30 shipped, so I will do that if its the noid that's gone.

How can I change the dwell? I have no xmod software.

A soldering iron will break the hardened solder thats on there right now. I got a brand new one sitting in my parts box extra I paid 39$ for it, I'd be willing to part for that + shipping. was keeping it on-hand if mine ever blew.

[Crap_Boy_Smith]

ok finally got the soldering tools necessary for removing the noid and did so (I do not think I damaged the board :)

anyway I cannot seem to get an ohmmeter reading from the noid on the multimeter setting of 200 ohms (where I was getting the high reading before)

However I can get a fluctuating reading of 1.6 up to 100 or so on 200 Mohms (the next one down from 200 ohms).

Is there anything else I should measure on the noid? Is it blown from those readings?

I am almost completely useless when it comes to electronics, so bear with my ineptitude

And thanks again for all the help. If it turns out the noid is blown I will be looking to buy that new noid from you...