Local mag help?

[gunangel]

Hey guys,

I'm not new to mags (I have a tuned and working pneumag) but despite that for some reason I cannot get my Lvl 10 to stop leaking in my classic valve. I've been reading through the posts on AO and it's been exhausting.

The setup is a classic valve with Lvl 10 using the carrier with no lines or dots and two shims. It fires one or so shots and then starts to vent. If I hold the trigger slightly it stops leaking. I have tried both fewer and more shims as well as different carriers but as I am missing the carrier with only dots so I cannot get very far.

So I was wondering if there is anyone in washington close to seattle or within an hour or so drive that has some spare parts and the knowledge to tech.

If not any online help will be helpful.

Thanks for taking the time to read this ridiculously long post

[csallen039]

try a different o-ring and start back at the beginning.

[gunangel]

thanks for the reply,

I ended up buying a replacement piston and sear (edge was worn), took out the shims, tuned up the velocity, played around with the ULT and I think it's shooting decently, but it leaks after a few shots...I guess I'll read through the Lvl 10 forum for the answer to stop that.