My friend got a classic mag off of pbgear, and the on/off pin and assembly is in backwards. I can't get it out, and he says it was working when he first got it and then it stopped. Do you guys have any idea of how to fix it?
-
Now that's the ugliest damn bong I've ever seen. -
If you cant get it out I suggest sending it in to the factory.Your Immortal Until You Die -
Use a slim pick (dental type) to work it out. The radical way is to rap it down onto a piece of wood, forcing the on/off assembly out. Make sure it is a soft piece of wood, no knots.
Comment
-
you could always gas it up with just the valve and not the rest of the gun. Make sure you dont have a bolt on there when you do this. I HIGHLY SUGGEST NOT DOING THIS! Use this as a last resort only.StEEl Grey SoNiC Cocker.The ownage Machine
Yellow to Orange Fade Defiant
14in Boomstick-TI
Orange Fade Warp/Orange-Faded Turbo Rev
Crossfire LPR 68/4500 w/ red cover
Black: Stickies, Lapco Drop, Macro.
PMI 68/4500 w/ Black DYE Cover
Comment
-
When you flip over the valve, do you see the pin and then the white o-ring? This would mean the bottom piece is in upside down and therefore you can't pull it out with your fingers. If this is the case, unscrew the regulator body and then stick a thin rod down the air passage that leads to the on/off assembly in the front valve body. Not the center hole. Stick the rod down the hole and press down and that hopefully should pop it out or at least give you enough to grab onto.Comment
-
hey bluntman! wheres Kronic?Comment
Comment