recently built a micro pne mag shot great but when I air'ed it up this weekend it started leaking out a pin size hole in the msv-2 located just in back of the firing lever anyone have any suggestion on how to fix all parts are new from ceyberave thanks for any help
-
-
I would contact Cyber. He should be able to help you on this. -
The LPR pressure is too high, turn it down, then re tune it, and you should be good to go.
Comment
-
lpr preasure
try'd that but does not work turn my lpr down till the leak stops but no trigger turn it up till I get trigger to work but it leaks but thanks for the anwserComment
-
have you oiled your msv2 yet? It's good to oil it before every use, just drop a drop of gold cup or automag oil (anything like that) into the "in" port on the msv2.
Easy way to do this is if you have an o-ring pick or something very thin, take the hose off and put the pick a little bit inside the "in" port, drop a small drop of oil down the pick tooth and it will slide into the port. Put the hose back on and you should be good.
I dunno if I explained that well or not, I can take a pic later of what i'm talking aboutComment
-
You can alway put a couple drops of oil in the asa near the lpr too. that is what I usually do. this way all the pneumatics get a littl oil.
Did you check to see if you msv-2 shifted at all. Sometimes they may move slightly, causing the lever to become partially activated, this will also cause the leak you described.
I have seen this in some of the pneumags I have had to trouble shoot in the past.
Hope this helps.......You know you want one!!Comment
-
Ditto. That's what it sounds like to me. Make sure your lever isn't stuck and that it can come out completely.Originally posted by LoguzzzzzzComment
-
pnemag
ok that was the problem a few drops of oil and is working fine thanks for the help next question will a x valve fit my micro frame have the micromag rt in it nowComment
-
Originally posted by rory
Yes the x-valve will fitComment
Comment