x-valve/level 10 leak after fire

[BenoitOWN]

Hi where I am at the moment I have limited acess to internet. I have an e-mag with x-valve and level 10. Now time to time after fire there is a leak at the tips of the level 10(like when it stick, I need to put on the level 10 bolt to make it stop) and I tryed shooting with it and it managed to have ball chop. Does anyone know what I need to do to fix it?

[SkinnyHare]

when was the last time you replaced the backing washer and the carrier o-ring?

[BenoitOWN]

I newly acquired it use from a guy on mcb so I don't know on that one. Another thing I have remarked is that it will seal back when I press the trigger(not to the points it shoot)

[Ruler_Mark]

trigger pressing affects the on/off and the hiss goes away because no new pressure is being put into the chamber. You just need to possibly replace the carrier o-ring and the nylon washer behund the carrier and re-tune your lvl-x

[BenoitOWN]

Ok thanks, now just beed to finds a credit card so I can order on agd website or if someone know a place with Paypal?

[Ruler_Mark]

Ok thanks, now just beed to finds a credit card so I can order on agd website or if someone know a place with Paypal?

http://www.tunamart.com

tunaman takes paypal, his prices are a lil bit higher on some things.

[athomas]

Try removing a shim or two first.