Warp feed

[Snap32]

Can you hook up warp feed to an 05 Angel Speed like you can with the LCD Angel and Intelli with the switch mod? if so.. how?

[211]

Yes
you can hook a warp to anything

[michbich]

Yup, the warp is independent of the brand of marker. The only thing that the warp is dependent on is the bracket to secure it on the marker.

[paintball72]

the warp can hook up to anything with 2 screws on the bottom of the asa in line with the gun. the only guns that i have seen that dont have this is the Tippmann a5 (possibly the x7 too not sure) and some lower grade spyders. and if you have a clamping feedneck all you have to do is grind off the clamping part of the white adaptor and it will work fine.

you cant do better than a warp

and just to clear up a myth about warps: you can shoot out the left hand side of your bunker (or visversa if you have the warp mounted on the right side) all you have to do is flop the gun on its side and vwola you can shoot out the left side to without exposing more than your barrel and edge of mask

[Snap32]

Sweet thanks

[Snap32]

Can it be hooked up with switch mod like Intelli and angel LCD?

[mstrdbz]

Now one more question, would it be able to keep up with my angel? it ropes...

If your board is intellifeed capable then yes. Pick up one of these harnesses and plug it into the angel board and the warp. The warp will then spin w/every trigger pull.

While I'm at it; here is a link to the warp manual. There's also one here for the angel-to-warp interface, but it's kinda outdated, as well as some other warp reference material.