Setup is emag x valve lvx normal tank. So I charged the batterie and just got my emag on/off today. Put the on off in and everything worked great for about half of a tank then I was going through the modes and trying them out. and now it will only shoot sometimes will shoot great walking it for about 20-30 shots then starts to not shoot still pull the trigger and nothing will happen. then i play with the trigger and it will shoot every once in a while. I am new to emags so any suggestions.
-
-
Ill try any suggestions you guys haveOriginally posted by UDO -
are you out of air or low on air? Tryadding some oil about 4 or 5 drops and running it through the marker. Whats your velocity set at? It might be a bit low.Comment
-
has plenty of air about 2200 psi could it be somthing having to do with the lvl x.Comment
-
what software are you running? the magnet that activates the HES might be set wrong, was fine inicially but then wiggled out of alignment.Comment
-
xmod 1.8Comment
-
did you try adjusting the trigger magnet that activates the hes??
Goto the mode on the board that shows when the trigger is read and the EYE is read, and set it up!Comment
-
Originally posted by Ruler_Mark
If that is not the culprit, read the part of the Xmod manual where it talks about adjusting your solenoid plunger.Comment
-
It was the velocity and I also had to change the lvl x spring.Comment
Comment