Pump mag issue

[mtaylor]

So my pump mag was working fine, then i swapped the frame on it. Now, it sounds almost like it is shooting full automatic, but i don't think the bolt is cycling all the way.

I think i am going to have to adjust the trigger... pin? Anyone have any other ideas, or advice on adjusting the trigger?

Thanks.

[secretweaponevan]

So my pump mag was working fine, then i swapped the frame on it. Now, it sounds almost like it is shooting full automatic, but i don't think the bolt is cycling all the way.

I think i am going to have to adjust the trigger... pin? Anyone have any other ideas, or advice on adjusting the trigger?

Thanks.

Engage safety. Gas up marker. Trigger rod should be 1/16" from back of trigger.

That and make sure your on/off o-ring is still in place.