What's wrong with this picture?

[ManInBlack]

Ok, I bought a 90* Vertical adapter for my warp setup. It Says on the website that this thing is to be used with vertical feed markers. I have a vertical ULE body, and the thing is obviously too small to fit in there. Am I missing a piece?

The Adapter:


Itsa too small...

[SOAD8789]

The flux capacitor is missing!

But really, it looks like its for warp feed bodies to use regular hoppers

[Looper]

You just need to use the TOOL you got in the first picture...

[Whee McGee]

ULEs weren't exactly designed for this in mind, I think. Rogue was selling vert Warp feednecks, which looks to be what you need. Maybe you should try sending him a PM over on the Legion.

You could always tape a ridiculous buttload of tape on there.

[secretweaponevan]

If you're handy, you could go get a short length of 1"OD PVC pipe and make your own adapter.

[ManInBlack]

Yeah, I could do that, but then I don't really see the point of having bought this thing. I mean, really, what's its purpose?

[Madmarx]

Yeah, I could do that, but then I don't really see the point of having bought this thing. I mean, really, what's its purpose?

That works with a warp body.

[ManInBlack]

Ok, I have a warp body here and it does fit on it. You could conceivably use this thing to put a hopper on a warp body, or more likely keep the tube from looping out the side too much. In any case, the website states,

"90 Degree Feed Adaptor is used with vertical feed markers to keep the feed hose low on the marker. "

Is it just me or would anyone else assume this means it is meant to be used with any vertical feed marker to keep the feed tube from looping around the top too much? I can see how this thing would be useful if I were using an old powerfeed body, but thats different than a vertical marker. I feel a bit mislead...

[secretweaponevan]

Aparently, you need the warpfeed feedneck. Give AGD a call.

[jhill112]

yes

yes go to ptp they have the warpfeed feedneck.the neck that is on the warp body.it is an angel thread also,so they may have one to.ptp is proteam products.take the neck off your body and put on the one that the 90 goes over.

[ManInBlack]

Aparently, you need the warpfeed feedneck. Give AGD a call.

You're suggesting I call AGD and get one of these


to replace the normal feedneck I have? I guess that would work. I didn't realize they would use the same Angel threads.

[TeamJackal37]

What I did for mine,I bought the cheapest Angel feedneck (one look like a funnel). I cut the Funnel off, use the straight part for warpfeed. It worked for me

[211]

you have it going on the wrong way in the second picture
you need a warp style feedneck, then the part with the screw clamp slides over the feedneck

[paintball72]

you have it the wrong way there is a part that goes on the end that you are putting in the feedneck that will go over it and allow the black hose to fit onto it but the end with the screw and such is used to go over smooth feednecks (ones that you need the plastic adapters to put the hopper on) but to get it to work in your feedneck just grind/cut whichever you prefer the part with plastic off for it to go into your feedneck. Its what i did on mine but i have a clamping feedneck so youll want to be careful and not cut off too much, but if it is too loose you can wrap it with electrical tape till it makes a snug fit.

i would post pictures but i dont have a working camera atm

[Ruler_Mark]

i got a extra warp neck, if ya want it shoot me a pm.